j-tec

J-TEC CO., LTD. Tokyo, Japan

Sales Program

COMPARISON BETWEEN TS 2 SERIES AND TS 3 SERIES

NC System
Position / Series TS 2 TS 3
Web Guide Sensor of Paper Roll Stand

Handle Unit
- Perforation position
- Perforation speed
- Handle patch glue position
- Handle patch glue speed
- Handle attaching position

Cutting Length
- Cutter speed
- 1st creasing position (flap volume)
- 2nd creasing position
- Bottom opening cylinder position
- Center gripper position
- Side gripper position
- 2nd gripper position
O


O
O
O
O
O


O
O
X
X
X
X
X
O


O
O
O
O
O


O
O
O
O
O
O
O
DIFFERENCES
The biggest difference between TS 2 and TS 3 series is the NC system at the large cylinder.
The NC controlling positions can be adjusted during operation without stopping the machine,
which can prevent the malformed (loss) bags come out when the machine stops to adjust.
As a result, bottom formation is easier and this insures the eventual faster size change.

SIZE CHANGE DATA (REFERENCE ONLY)

The following data were actually taken at the size change stage of each
model at Newlong Industrial's factory by factory staff.
Models Time (min.)
Model 158T+504TH, 127T+504TH, etc.
TS 2 (TS2746H, TS2755H)
TS 3 (TS3636H, TS3746H)
200
85
50
・Specifications are subject to change without notice.
・Speed always depends on conditions.